Meets or exceeds all applicable requirements of ANSI/AWWA C515 Standard, UL 262 Listed (thru 24”), FM 1120/1130 Approved (thru 16”), and certified to NSF/ANSI/CAN 61 and 372
Mechanical joint end complies with ANSI/AWWA C111 Standard.
Ductile Iron body and bonnet with nominal 10 mils Pro-Gard® Fusion Bonded Epoxy Coated interior and exterior surfaces; 42" and 48" valves coated with HP Epoxy coating.
Epoxy coating meets or exceeds all applicable requirements of ANSI/AWWA C550 Standard.
Ductile Iron wedge, symmetrical & fully encapsulated with molded rubber; no exposed iron.
Non-rising stem (NRS)
Triple O-ring seal stuffing box (2 above the thrust collar and 1 below)
2" square wrench nut (optional bevel or spur gearing) – open left or open right. 30"-48" require a Spur Gear or Bevel Gear
250 psig (1725 kPa/17 barg) maximum working pressure, 500 psig (3400 kPa/34 barg) static test pressure
14" and 16" sizes – UL Listed, FM Approved: 250 psig (1725 kPa/17 barg)
18", 20" and 24" sizes – UL Listed: 175 psig (1200 kPa/12 barg); FM Approved: 250 psig (1725 kPa/17 barg)
